What email address or phone number would you like to use to sign in to Docs.com?
If you already have an account that you use with Office or other Microsoft services, enter it here.
Or sign in with:
Signing in allows you to download and like content, and it provides the authors analytical data about your interactions with their content.
Embed code for: Part 3
Select a size
This the picture of the top
This is the picture of the side
This is the picture of the front
These are the pictures of each part of the generator:
2. The dimension of our facility will be approximately 1 square.
3. Firstly, let the KT board stuck on the board and then put the milk box on the board. Secondly, use scissors two holes at opposite sides of the milk box and then cut the top of the milk box.
Thirdly, put the two crabsticks into the milk box. Next, put the two crabsticks on the plastic pipe. After that, put the iron bar in the middle of the milk box. Using magnet put on the iron bar. LED lights should be cascade.
Fourthly, connect the strings on the plastic pipe. Put the blades on the iron bar.
Tips: 1. There must be a sponge in the middle of the magnet.
2. The way to connect the lights and the strings should be series connected.
4. Life cycle: We can use it to get lighting. If we use it, it will reduce a little bit carbon
dioxide. We will throw it when it will not work.
KT board (Let the crabsticks into the milk box easier)
Fan (When the fan was blew by the wind, will make the iron bar rotate.)
Iron bar (It can make the magnets rotate.)
Sponge (It can avoid the magnets connect with each other.)
Enameled wire (This is the most important part of the facility, it is conductor)
Plastic pipe (It can insulate the magnet to connect with the strings)
Magnets (The same as the generator in our facility)
Crabsticks (The same as the supporter in our facility)
Milk box (The same as a container in our facility)
LED bulbs (We will make it shining for our facility)
These are all our design process.
Group: Bonnie Li, Healer Lucia